WARNING
1. This appliance is not intended for use by persons(including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction concerning the use of the
appliance by a person responsible for their safety.
2. Children should be supervised to ensure that do not play with the appliance.
3. The appliance is intended to be permanently connected to the water mains and
not connected by a hose-set.
4. The maximum inlet water pressure of 0.8MPa for the correct operation of the
appliance.
5. The installation of this product has to abide by Surahanjaya Tenaga
Malaysia. Our
company is not liable for any damage caused by improper installation or failure to
comply with the instruction indicated in the user manual.
6. The electric supply must comply with the specifications in the technical table.
7. The storage water heater must be permanetly connected to the electricity supply
through a double-pole linked switch having a contact separation of at least 3mm in
all poles incorporated in the circuit.
8. It is recommented to install an approved residual current device(RCD) of 10mA
sensitivity and higher than heater rated current.
9. The pressure relief valve supplied with the heater must not be tampered with or
replaced.
10. Slight dripping of water from pressure relief valve is normal during the heating
process.
11. The overflow tube connected to the drain nozzle of pressure relief valve must be
kept slopine downwards & unblocked.
12. For the first use of the heater or after maintenance or clean, ensure the heater is
fully filled with water & air inside the tank has cleared befored swithing on the
heater.
13. The installation must be carried out by a qualified plumber/electricician.
14. Do not use ABS or PVC plastic pipes for the inlet and outlet pipe connections.
Use only recommended stainless steel, copper or polymer pipe which can
withstand high temperature and pressure.
1
15. Do not install in area where the water supply EXCEED 20mg/LITER(20ppm) of
CHLORIDE as this will cause corrosion to the stainless steel heater tank and void
the warranty.
