INSTALLATION GUIDE
1. The heater must be installed on a solid wall and near to the point of use for
convenience of water and electrical supply as well as easier for future
maintenance to make sure the location is free from water flash. The selected
location must support a weight two times that of the total weight of the heater
fully filled with water.
Please ensure to use the mounting kits supplied with the heater.
(
refer to fig.1)
2. According to site requirements, you may regulate the position of the flexible
mounting bracket to floor, ceiling or wall mounting configuration.
Once the position is confirmed, please ensure to secure the explosive bolts onto
the heater and note that always tighten the supporting screws at the bottom part
of the heater.
2a. Floor Type Mounting
Tighten the supporting screws at the bottom part of the heater without installing
explosive bolts(refer to fig.2)
Explosive Bolts
Flexible Mounting Bracket
(fig.1)
(fig.2)
Supporting Screws
Hot outlet
Cold inlet
4
Please install the heater
according to the direction
of the arrow.
