RTS OMNEO OEI-2, User Manual, Page: 36 / 40

36 Configuration OEI-2
Bosch Security Systems, Inc. Technical Manual F.01U.287.527 Rev. 01
Power On Reset
The Power On Reset Mode allows the user to cycle power to the OEI-2 unit.
To configure the Power On Reset mode from the front panel of the OEI-2 , do the following:
1.
Using a straightened paperclip, press and hold the MODE SEL button for 10 seconds .
The POWER and MODE LEDs start blinking .
2.
Remove the straightened paperclip from the MODE SEL button.
The POWER LED turns off. The OEI-2 is configured for POWER ON Reset Mode .
IMPORTANT: If the MODE SEL button is held past 15 seconds the MODE LEDs stop flashing and show the existing
MODE settings. This means the reset configuration did not occur.
FIGURE 17.
Power On Reset