RTS OMNEO OEI-2, User Manual, Page: 35 / 40

OEI-2 Configuration 35
Bosch Security Systems, Inc. Technical Manual F.01U.287.527 Rev. 01
Mode 3 - Select Port for GPI
Select Port for GPIO Mode is used in conjunction with Mode 2. When 1 Keypanel Mode is selected, the user can select the
port the GPI/Os are assigned.
Reset Configuration
Reset Configuration Mode allows the user to reset all modes to the factory defaults. This also turns all the LEDs off.
To reset the configuration from the front panel of the OEI-2 , do the following:
1.
Using a straightened paperclip, press and hold the MODE SEL button for six (6) seconds .
All four (4) MODE LEDs start blinking .
2.
Remove the straightened paperclip from the MODE SEL button.
The LEDs turn off. The OEI-2 is reset to Factory default .
IMPORTANT: If the MODE SEL button is held past eight (8) seconds the MODE LEDs stop flashing and show the
existing MODE settings. This means the reset configuration did not occur.
FIGURE 16.
Reset Configuration