RTS KP-4016, Technical Manual

Page: 248 / 306

248 KP-4016/5032 Menu System KP Series
Bosch Security Systems, Inc. Technical Manual F.01U.304.914 Rev. 05
Service Menu, Mirror (Control Package Only)
The Mirror menu provides a scroll list of keypanels which can be the target of a mirror operation. All KP-Series units can be
a mirror target, a license is not required for targets.
NOTE: This menu option is not shown if the port has mirroring disabled. See “Keypanel Mirroring (Control Package
Only)” on page 96.
To take control of a target keypanel , do the following:
1.
On the keypanel, starting at the Service menu, select Mirror .
2.
Press the SEL button .
A list of available target keypanels appear in the panel display .
IMPORTANT: Only panels that are locally scroll enabled are display in the available target keypanels list. If they are
not in your scroll list, you cannot mirror them.
3.
Using the arrow buttons, scroll to the target keypanel .
4.
Press the SEL button .
The Supervisor keypanel updates and displays the target keypanel’s image.
To exit Mirror mode on the keypanel , do the following:
1.
On the keypanel, starting at the Service menu, select Mirror .
2.
Press the SEL button .
The alpha of the target and Exit appear in the panel display .
3.
Using the arrow buttons or Aux Volume shaft encoder, select Exit .
4.
Press the SEL button .
The mirroring target and supervisor icons disappear and keypanels go back to normal operation.
Service Menu, OMNEO Setup
The OMNEO Setup menu option is used to configure the OMNEO device name, enable DHCP, address the OMNEO device
for the keypanel and set up the static IP configuration, if DHCP is disabled.
NOTE: OMNEO and RVON technologies cannot be used at the same time on the same keypanel. Use either RVON or
OMNEO, but not both.
IMPORTANT: If you change the device name on the keypanel, you must change how other devices are configured, so
they can continue to make connection offers to this keypanel.
IMPORTANT: After making any change to the OMNEO Setup, the keypanel resets to activate the changes. The reset
occurs five seconds after exiting the menu system.
To enable DHCP from the keypanel , do the following:
1.
Starting at the Service|OMNEO Setup menu, select OKP .
NOTE: OKP refers to the OMNEO keypanel using the OMNEO connection; however, if an OEI-2 is also attached to
the AIO port, you see both OKP and OEI-2 options for selection.
2.
Press the SEL button .
Device Name, DHCP, and IP Parameters appear in the panel display .
3.
Using the arrow buttons, select DHCP .