Universal Beltpack
Initial Setup and Configuration 27
Send Mic Kill Menu (RTS and Audiocom Mode Only)
The
Send Mic Kill
menu is used to send a mic kill signal to shut off a microphone on a beltpack , user
station, or master station that has been inadvertently left on. A 24 kHz signal is sent to the party-line
where the beltpack with the microphone left on, signalling it to shut off.
Available options are
Yes
or
No
.
IMPORTANT:
The Send Mic Kill is not sent until the beltpack has exited the program menu.
The program menu must be exited before the mic kill signal will be sent.
To
send a mic kill
, do the following:
1.
While in the program menu, navigate to
Send Mic Kill
.
[voice prompt] “Send Mic Kill”.
2.
Press the
TALK button
.
[voice prompt] “No”.
OR
Press the
TALK button
again.
[voice prompt] “Yes”.
3.
Exit the
Program Menu
(see “Exit Program Menu” on page 20).
LEDs Menu
The
LEDs menu
is used to set the LEDs to normal intensity or dimmed on a beltpack.
Available options are
On
or
DIM.
The default for this menu is
On
.
To
configure LEDs
, do the following:
1.
While in the program menu, navigate to
LEDs
.
[voice prompt] “LEDs”.
2.
Press the
TALK button
.
[voice prompt] “On”.
OR
Press the
TALK button
again.
[voice prompt] “DIM”.
3.
Exit the
Program Menu
.
Summary of Contents for BP-4000
