26 Initial Setup and Configuration
Universal Beltpack
Power Source Menu (RTS Mode Only)
The
Power Source
menu is used to select which channel the beltpack draws power. By distributing the
power draw, more beltpacks can be used on the same party-line.
Available options are
Channel 1
or
Channel 2
.
The default for this menu is
Channel 1
.
To
configure the power source
, do the following:
1.
While in the program menu, navigate to
Power
.
[voice prompt] “Power”.
2.
Press the
TALK button
to select Channel 1.
[voice prompt] “Channel 1”.
OR
Press the
TALK button twice
to select Channel 2.
[voice prompt] “Channel 2”.
3.
Exit the
Program Menu
(see “Exit Program Menu” on page 20).
Mic Kill Menu (RTS and Audiocom Mode Only)
The
Mic Kill
menu is used to enable or disable the ability to ignore a Send Mic Kill signal sent to turn off
the mic on the beltpack.
Available options are
On
or
Off
.
The default for this menu is
On
.
To
configure mic kill
, do the following:
1.
While in the program menu, navigate to
Mic Kill
.
[voice prompt] “Mic Kill”.
2.
Press the
TALK button
.
[voice prompt] “On”.
OR
Press the
TALK button
again.
[voice prompt] “Off”.
3.
Exit the
Program Menu
(see “Exit Program Menu” on page 20).
Summary of Contents for BP-4000
