CHAPTER 2
Initial Setup and Configuration
Initial BP-4000/5000 Setup
The BP-4000/5000 has a mode-sensing setup built into it. Mode-sensing detects the system configuration
and then sets the beltpack to run in this mode. Mode-sensing setup is activated by pressing a sequence of
buttons on the beltpack.
The mode of the BP-4000/5000 needs to be correctly reconfigured either through mode-sensing setup or
the program menu. The mode can be verified by the sequence of flashing LEDs upon power up or
through the program menu.
NOTE:
Using the mode-sensing setup on pre-configured beltpacks does not change any of the
programmable settings.
The factory setting for the BP-4000/5000 is RTS mode. For more information on the different modes of
operation, see “System Configuration” on page 13.
Summary of Contents for BP-4000
