RTI TheaterTouch T2, User'S Manual And Programming Manual

Page: 53 / 118

Chapter 5 • TheaterTouch Designer Advanced Features
43
The
Edit Infrared Command
options are:
Minimum Repeats -
Enter in this box the number of times that the repeating
part of the IR code is sent by the remote. Some infrared receivers need a
command to be repeated a certain number of times to work properly, and
some may not work properly if the command is repeated at all. Even if a
command works properly, increasing the number of repeat times may be
necessary if the command is to be used in a macro. Since macro commands
are not automatically sustained while a button is pressed, they may need to
automatically repeat more times to be recognized.
Frequency – Shown in this box is the carrier frequency of the IR code, this is
set automatically. You should not need to change this value unless directed to
do so by Technical Support.
Repeat while button is pressed - Check this box to cause this IR code to be
repeated for as long as the button is held down.
Note: Only one command in any macro can have this property set.
Output Type:
Unless the system contains a mixture of direct IR and IRF-6/RF commands,
this option will not normally need to be changed.
Default - Check this option to set the default output type for this
command to the button default. The button default is the option
selected on the
Output tab of the Edit Button Properties command.
IR - Check this box to force this command to transmit IR directly out
the infrared window on the front of the remote, regardless of the
system setting.
RF - Check this box to force this command button to transmit IR via RF
through the IRF-6, regardless of the system setting.
RF ID Code:
Unless the system contains more than one IRF-6, this option will not normally
need to be changed.
Default - Check this option to set the default RF ID code for this
command to the button default. The button default is the ID code
selected on the
Output tab of the Edit Button Properties command.
Code - Check this option and enter an ID Code in the box to force this
command to transmit a specific RF ID code when in RF mode,
regardless of the system default setting.