6. Fitting the roof part 1
Lift the assembled roof sections onto the building, make sure the top edges are located at the apex and there is an even overhang at each end. From the outside secure
the roof section on the back of the building with 6 x 38mm screws as shown, screw through the roof and roof framing into the top of the wall panels. Attach the front roof
section in the same way using 4 x 38mm screws. From inside the building attach the roof panel framing at the ends of the building to the apex panels using 4 x 50mm screws.
Fix a gusset to the roof rafters using 2 x 30mm nails per gusset.
50mm
38mm
38mm
30mm
30mm
7. Fitting the roof part 2
Align to the internal angled roof edges the two roof join covers, with the bottom edges flush to the roof panel framing, fix in place using 4 x 35mm screws. screw through
the cover into the angled roof panel framing. Assemble the roof centre block with the internal roof capping, have the block sitting central on the cap except at the angled
end where the two components should be flush with each other. Secure the capping to the centre block using 3 x 50mm screws. Screw through the cap into the block as
shown. Lift the two hip roof panels onto the wall and angled roof panels as shown. Ensure they are hooked over the wall panels and butted up against the main roof. From
inside, Fix the panels down to the wall panels using 2 x 50mm screws per panel, screw through the roof panel frame into the top of the wall panels. Using 1 x 38mm screws
per hip roof panel screw through the angled roof panels into the ends of the top frame of the hip roof panels. Position the roof centre block between the hip roof panels
with the angled end sitting on the main roof, secure in place using 6 x 38mm screws. Screw up through the capping piece into the framing of the hip roof panels. On the
outside of the building secure the hip roof panels to the roof join covers using 3 x 32mm screws evenly spaced along the panel.
35mm
38mm
50mm
50mm
32mm
Important note
From the inside of the building, screw
through the main roof into the top roof frame
of each hip roof panel using 1 x 38mm screw
per roof panel.
Screw into apex panel
Screw into apex panel
Important note
Ensure the bottom edge of
the roof join covers are
flush to the edges of the
main roof panel framing.
Roof centre block and inside capping
Side view
End view
Assemble component
32mm
It is recommended to drill pilot holes with a
3mm drill bit for all screws in this section.
3mm
Drill
It is recommended to drill pilot holes with a
3mm drill bit for all screws in this section.
3mm
Drill
38mm
