Fountain Tower
O W N E R S M A N U A L
CONTENTS:
INSTRUCTIONS:
INSERTING & CHANGING BATTERIES (4D CELL BATTERIES NOT INCLUDED):
FOUNTAIN DIAGRAM:
Fountain Tower
Dancing Water
Attachment
Water Pump
Tube
Water Pump
Water
Pump
Water Pump
Discharge
Tube
Pump Power
Cord Connector
Battery
Compartment
(4D Cell
Batteries)
Dancing
Water
Attachment
Water Pump
Tube
Water
Level (3”)
Bowl
(Not Included)
1. Find a suitable bowl and place on a flat, level surface and place the Fountain Tower into the center of the bowl.
2. Connect one side of the water tube to the water pump and the other end to the bottom side of the Battery Compartment (Figure 2a). Connect The power cable of the Water Pump
to the power cable on the battery compartment (Figure 2b). Lower the Battery/Water pump Assembly into the Fountain Tower (Figure 2c). See instruction below on how to insert &
change the batteries.
3. Fill bowl with water, water level should be approximately 3 inches, this will ensure water covers the water pump (see fountain diagram).
4. Turn on your new Bernini
TM
Fountain and enjoy.
OPERATING YOUR FOUNTAIN TOWER:
The pump must be off to reset run time and durations: Set the duration of operation from 1 hour to 4 hours by pressing the button 1 to 4 times, when the button is pressed the pump
will start running. 3 seconds after the button is pressed and you are finish setting the duration, within 3 seconds, the LED will flash the number of times the button was pressed. After
the LED flashes to confirm duration and the pump is spraying water, the duration is set and cannot be changed unless reset. You can stop the pump once by pressing the button for
over 2 seconds. But the pump will repeat spray water the next day. If you want to change the setting of duration, stop the pump by press the button over 2 seconds. The pump will
stop. Only when the pump not spraying water, you can press the button again to set the duration. The pump will start 24 hours after the new setting.
You may want to reset the pump so that it will not spray water automatically next day. If the pump is spray water, press the button over 2 seconds to stop it.
When the pump is NOT spraying, simply press the button over 2 seconds and the LED will light 3 seconds to confirm no
DANCING WATER ATTACHMENT: (OPTIONAL):
When fountain is not running, connect the Dancing Water Attachment to the outlet in the middle of the Fountain Tower.
Figure 1
Figure 6
Figure 3a
Figure 4b
Figure 3b
Figure 2
4 Clips
Figure 5a
Figure 5b
Dancing Water Attachment
Figure
2a
Figure 2c
Figure
2b
Figure 4a
1. Ensure fountain is not running.
2. Lift out battery and pump assembly (Figure 1).
3. Set pump assembly on a flat sturdy surface (Figure 2).
4. Un clip the (4) battery retaining clips (Figure 3a, 3b and 5a).
5. Insert 2 batteries with the (+) side facing up and 2 batteries with
the (-) facing down (Figure 4 & 4a).
6. Re-clip the (4) battery retaining clips (Figure 5b).
7. Re insert the battery and pump assembly into the Fountain Tower (Figure 6).
8. When installing or reinstalling the battery and pump assembly into the Fountain Tower ensure that top plate of the battery & pump
assembly sits flat on top of Fountain Tower to prevent water from leaking into assembly reducing fountain performance.
Battery
Compartment
Need Help?
Call us for assistance at +1 (619) 449-2392
or you can email us at: [email protected]
Our Customer Care Department is available:
Monday - Friday 8:30am to 4:00pm PST / 11:30am - 7:00pm EST
Recommended minimum bowl size is approximately 12 inches
