It is recommended to drill pilot holes with a
3mm drill bit for all screws in this section.
end panel
Side panel
50mm
Panel frames
rest on floor.
Panel cladding
overhangs floor
edge.
3mm
Drill
2. Wall panels
Position an end panel and a large side panel on the floor as shown. Note how the panel frames sit on the floor with the panel cladding overhanging the floor edge. Ensure
square and secure using 4 x 50mm screws, screw through the frame of the end panel into the frame of the side panel. Position the small back panel next to the first, ensure
square and secure them together in the same way. Continue adding the rest of the panels and corner posts as shown in the diagrams using 4 x 50mm screws per join.
Important note
To "
VALIDATE
" the guarantee, adequate provision must
be made to ensure ground contact is avoided and air is
able to circulate underneath the building.
Placing the building on a concrete pad or slab base is
acceptable provided that the building is not allowed to sit
in pooled water during wet conditions.
If the building is to sit on soil or grass it
MUST
be
erected on pressure treated wooden 50mm x 50mm or
similar bearers
(These are not supplied in the kit).
Rowlinson Garden Products recommend using pressure
treated bearers with all buildings on any type of base.
Door end panels
Back panels
End panels
Window panels
50mm
50mm
Large back panel
1175mm
Small back
panel 600mm
Corner post
with notch
Right-hand
window panel
Window
panel
Window panel
Window panel
Left-hand window panel
Corner post
front wall panel
1125mm
End panel
850mm
Door end panels
Corner posts
End panel 850mm
Large back panel 1175mm
50mm
50mm
50mm
50mm
Left-hand
window panel
Right-hand
window panel
Floor
1. Floor panels
Prepare a level area for the shed to sit. With the three rectangular floor panels upside down, join them together using 4 x 50mm screws for each join .Turn the floor up
the right way and place into position. Place the floor side extension piece either to the right or left of the side edge of the main floor. Check that the whole floor is sitting
level.
Orientation
of notch
Corner post
with notch
