background image

 

Document: 

RE-BCC8FDM 1C7  

Document: 

RE-BCC8FDM 1C7  

Document: 

RE-BCC8FDM 1C7  

Page:

 1 

Page:

 1 

OWNER'S MANUAL

RE-BCC8FDM camera license plate

DSE srl - Digital Surveillance Equipment - WWW.DSE.EU

RE-BCC8FDM  

PRODUCT DESCRIPTION 

This camera is made to allow the resumption of license plates of vehicles in slow or fast motion. It 
can operate in any light condition thanks to

infrared illuminators 

incorporated. Thanks to a

System of High-Light Suppression is not affected by the headlights of the vehicle is that dipped 
beam.  

ASSEMBLY 

The cameras are equipped with a mounting bracket for wall built to allow the passage of cables 
within it.  

The bracket is mounted generally in 

matching output cables. The basis of

fixing 

It has 4 holes for fixing to the wall with dowels. The housing is waterproof and can be installed 
outdoors without any protection.  

The housing is air-conditioned and is equipped with a fan which is activated at above 45 ° and a 
heater that is activated at below -5 ° C. 

POSITIONING 

The positioning of the camera it is very important for a good yield of the license plate reading.  

The optimal recovery of the plate is carried out at a maximum distance of 30 m. depending on the 
adjustment of the lens. The first thing to check is therefore that the distance as the crow flies (not 
walkable on the ground) between the camera and the point where you will find the means, does 
not exceed this distance otherwise the infrared lighting will not be effective.

The second thing to consider is to position the camera so that the light of the 

headlights is not 

directly oriented towards the camera, while maintaining an angle of approximately 30 ° with 
respect to the illumination of the headlights. The camera will then be placed in detected position 
with respect to the road surface so as to avoid that the dot headlights directly against the camera. 
Satisfied

the two previous points, orienting the 

the camera needs to be done so that the plate remains as long as possible in the field of vision of 
the camera. 

SENSOR BRIGHTNESS 'BACK 

The camera is equipped with a sensor that allows CDS 

detect ambient light and is positioned in the rear to prevent false readings due to car 

headlights. The sensor is placed in the rear of the housing grommet.

Absolutely necessary to avoid that light sources should be to distort the detection of this sensor, 
because in this case the camera will not operate properly at night. Above all we must avoid the 
presence of

headlights 

lighting in the vicinity of the camera that would prevent the ignition of the LEDs. 

CONNECTIONS 

The connections on the output cable from the camera are the following:

BNC video output

 - At the BNC female bayonet connecting the video cable that leads then to 

BNC video output

 - At the BNC female bayonet connecting the video cable that leads then to 

monitor or management devices typically using RG59 coaxial cable and BNC connector. The 
RE-BCC8 .. cameras cameras are able to operate either with regular analog DVR or DVR

AHD last generation with which allow to reach the resolution of Full HD 1080P 1920x1080 (2 
MP). 

The switching between the two systems TRADITIONAL CVBS and AHD is carried out by 
commands from the RS485 as we shall see later. 

A AHD DVR 1080P can receive the camera is in the normal analog CVBS mode that AHD, but 
will agree to use the equipment that provides greater resolution. An older generation analogue 
DVR, or an AHD 720P DVR, you can see only in CVBS mode camera.

Reviews: