UNIVERSAL TOASTER UTX-200L
16
P/N 1010992 Rev. K 03/15
McDonald’s
Figure 8. Back Panel Release Latches
SELE
CT
SELEC
T
LOCKED
UNLOCKED
(Horizontal)
(Vertical)
Release Latches (on
BOTH sides of the rear of
the unit) are locked when
in the horizontal position.
Turn both latches to the
vertical position to open
and unlock the Back
Panel.
Figure 9. Master Links
Screws
2. Apply
McD© Heavy Duty Degreaser (HCS)
on
a
clean, sanitizer soaked grill cloth.
Wipe the
exposed part of the Conveyor Belt with the grill
cloth from side to side. Use the master links for
reference (Figure 9).
b. Use a no-scratch pad to spread a light coating
of grill cleaner over the entire exposed part of
the conveyor belt.
c. Lightly scrub the belt with the non-scratch pad
until clean.
6. Install the Release Sheet onto the Release Sheet
Retainer Bar and install onto unit.
NOTE: Rotate the Release Sheet from side to side
daily to extend the life of the Release Sheet.
7. Reattach all accessories to the unit (Figure 1).
NOTE: Check the Release Sheet to make sure it is
draped properly over the Platen.
MAINTENANCE (continued)
Figure 10. Back Panel Release Latches
SELECT
SELECT
LOCKED
UNLOCKED
(Horizontal)
(Vertical)
Release Latches (on
BOTH sides of the rear of
the unit) are locked when
in the horizontal position.
Close the Back Panel
and turn both latches to
the horizontal position to
secure the Back Panel.
3. Press and hold both
MUFFIN/BAGEL
selector
buttons on the back of the unit (Figure 6) until to
uncleaned portion of the belt is exposed. Repeat
Step 2 on the uncleaned portion of the belt.
4. Rinse/wipe the vertical Conveyor Belt with
the grain (Side to side) using
KAYQUAT II™
Sanitizer Solution (HCS)
and allow to air dry.
NOTE: Do NOT leave the Back Panel open any
longer than it takes to complete these cleaning
procedures. Refer to the cleaning label located on
the back of the unit.
5. Follow this step only if the vertical conveyor belt
does not become clean after steps 2 through 4:
a. Open a packet of
McD Hi-Temp Grill Cleaner
(HCS)
. Empty the contents on an entrée base.
8. Verify that the Bun Thickness Compression
Control knob is set to 3 (Figure 2).
9. Close the Back Panel and lock the Back Panel
Release Latches (Figure 10).
10. Place the toaster back into operation.
WEEKLY & SEMI ANNUALLY: Clean
Cooling Fans
Refer to the document
UTX-200 Cooling Fan and
Blower Motor Cleaning Instructions
(
P/N 1011059)
and follow the directions in that document to clean
the cooling fans, blower motor, and electrical com-
partment. This document provides Weekly & Semi-
annual tasks.
NOTE: It is very important to keep the cooling
fans, blower motor, and electrical compartment
clean and in top operational mode. Do not ignore
these cleaning steps.
Summary of Contents for 9210805
Page 20: ......