Rottler P69AHD, Operation And Maintenance Manual

Page: 14 / 210

Section 2 Installation P69AHD Manual
www.rottlermfg.com
2-3
IF VOLTAGE IS OUTSIDE THE CORRECT RANGE AT ANY TIME THE
MACHINE WILL NOT OPERATE PROPERLY AND MAY BE DAMAGED.
______The P69AHD machine must have a ground rod installed. Not having a ground rod installed
can cause unexpected movement of the machine. Refer to the Operation Manual for correct
installation of the ground rod.
______Briefly describe the isolated ground connection to the machine you have made: (Instructions to
make a correct isolated ground are included in the operating manual.
_____________________________________________________________________________
_____________________________________________________________________________
______Air of the proper pressure and capacity connected to the machine. Air supply must be free from oil
and water. Oil or water will damage electrical and air components.
______Remove the ball screw locks on the left side of the table for the X axis, and the front of the table
for the Y axis. They may be covered up by the way covers.
______Place a thin film of silicone on one side of the ball screw caps and install them in place of both the
X and Y axis locks.
______Air of the proper pressure and capacity connected to the machine. Air supply must be free from oil
and water. Oil or water will damage electrical and air components.
______Customer should attempt to have junk work piece available.
______Have the operator read through the operation manual before training begins. This will help him
be familiar with the button pushing sequences. Have the operator read through the manual again
after training and some of the sequences will make more sense.
______Have Internet connection available for the machine. Either via Ethernet cable or Wireless (Wi-Fi).
The machine comes equipped with a wireless USB adapter.
Rottler technician Installation checklist:
______ BEFORE turning power on to the machine. Check all wires for security by using the correct screw
driver and turning CW until movement stops. Stranded wire can “spread” slightly from vibration
during transport.
______Install electrical component covers inside the electrical enclosure with fasteners provided.
______Each main system is protected internally by circuit breakers. Green the breaker is “tripped” and
red indicates the breaker is “Hot” (conducting electricity).