11. Assembly
41
Rev.D 2013_03_en
37
6.
Connect the pneumatic lines of the adjustable
runway to the two T-connectors (
Pneumatic
circuit diagram).
7.
For variants with rolling jacks:
Route the hydraulic line of the adjustable run-
way in the cross beams and through the fitting
(
Fig. 34).
11.7 Set up the cables
38
1.
Pull out the 4 cables according to the cable
diagram through the cross beam and route them
out of the cross beams. They must protrude
from the cross beam by about the same dis-
tance.
ATTENTION
Malfunction if cables are crossed
or slack.
Ensure that the cables are pulled tight within
the cross beam and are not crossed.
2.
Fit the cross beam cable sheaves (
Fig. 30
and 33). To do so, insert the cable sheave and
the two distance sleeves into the cross beam for
each cross beam. Slide the greased axle into
the side and secure the guide.
11.8 Fasten the runways to the cross
beams
39
1.
Align the fixed and adjustable runways with the
cross beam mounting holes (S) at the front and
back. In doing so, make sure that the cables
and lines are in the correct position. Cables
must not fall out of the grooves of the sheaves.
For alternative mounting positions for the ad-
justable runways, see
Pos. (L) and (R).
40
2.
Check the difference in length between the two
lift diagonals (between the corner points of the
cross beams). Maximum allowed difference be-
tween the two diagonals = 6 mm.
Difference in diagonals < 6 mm