12
|
In
Program Mode,
the black parameter
buttons are used to select parameters for
editing and to load and save presets and
sequences. In
Play Mode,
they are used for
real time control input as indicated by their
blue function labels.
Setting Parameters
As just mentioned, the
Time
and
Level
parameters are each set by adjusting their
respective knobs. Whenever their value is
displayed for editing, the
Encoder
can be
used for fine adjustment.
The
Level Mode
is set by repeatedly pressing
the
Mode/Quantize
button until the desired
value is is displayed in the
Program Mode
display. See
Chapter 9
for details.
All other parameters are set by pressing their
parameter button to display the parameter’s
current value and then using the Encoder to
set the desired value.
The value change is always effective
immediately. Pressing the parameter’s button
while the parameter is displayed, or pressing
the encoder, will exit the screen. The new
parameter value remains in effect in either
case.
IMPORTANT NOTE:
Whenever there are any
unsaved parameter changes in a preset or
sequence, a red warning (
P
for Preset and
S
for Sequence) will appear in both the
Play and Program displays. If you select a new
preset or sequence before saving them, the
changes will be lost.
Copying Segments and Parameters
For ease of programming multiple segments
that may share some or all of their
parameters, the following copying functions
are available:
To copy a particular parameter value
from one segment to another:
In Program Mode:
1. Select the segment whose parameter
value you want to copy and bring the
parameter’s value up for editing.
2. Press and hold the source segment button
and, while holding it, press and hold the
segment button of the segment you want
to copy the parameter value to.
3. After holding the destination button for
about a second, the message “Parameter
copied” will appear in the display and,
not unexpectedly, the parameter value
will have been copied to the destination
segment and the destination segment will
be selected.
4. The destination segment will be selected,
but if you continue holding the original
source segment button, you can repeat
the procedure and sequentially copy the
same source parameter value to as many
of the other segments as you wish.
To copy all of the parameter values from
one segment to another:
In Program Mode:
1. Select the segment whose parameter
values you want to copy. Do not bring up
any parameter edit boxes.
2. Press and hold the source segment button
and, while holding it, press and hold the
segment button of the segment you want
to copy all the parameter values to.
3. After holding the destination button for
Summary of Contents for Control Forge
Page 70: ...70 ...
