Ross ACO-4400A, User Manual, Page: 24 / 112

2–6 • Physical Installation ACO-4400A User Manual (Iss. 03)
Connecting an SRG-4400 to an ACO-4400A
Each SRG-4400 (Primary and Backup) can connect directly to the ACO-4400A rear panel via an
Interface Cable (4400CR-100-01). The Breakout PCB Kit that came with your SRG-4400 will be
mounted and installed in the chapter “
Installing the Breakout PCB ” on page 4-1.
Connecting the Primary SRG-4400 to the ACO-4400A
The Primary SRG-4400 connects directly to the ACO-4400A via its BALANCED connector and
the Interface Cable (4400CR-100-01). This cable has red and violet wires, and two 30-pin
Connectors.
To connect the Primary SRG-4400 to the ACO-4400A
1. Connect one end of the Interface Cable (4400CR-100-01) to the BALANCED
connector on the primary SRG-4400 rear panel.
2. Connect the other end of the same Interface Cable to the bottom 30-pin Connector on
the ACO-4400A rear panel. Refer to Figure 2.2 .
Figure 2.2 Connecting the Primary SRG-4400 to the ACO-4400A Rear Panel
ACO-4400A
GPI/RS232
100-BaseT
— 7 — BACKUP PRIMARY BACKUP
BACKUP — 2 —
— 8 — PRIMARY BACKUP — 9 — PRIMARY BACKUP — 10 — PRIMARY BACKUP — 11 — PRIMARY BACKUP — 12 — PRIMARY
BACKUP — 1 — PRIMARY PRIMARY BACKUP BACKUP BACKUP BACKUP — 3 — — 4 — — 5 — — 6 — PRIMARY PRIMARY PRIMARY PRIMARY
Primary SRG-4400
GPI/RS232
100-BaseT
GPS 1Hz 10MHz IN 10MHz WK/TTL1 WK/TTL2 6Hz/TTL3 DARS AES 1 AES 2
SDI 2 BLACK
BALANCED AUDIO/AES/LTC
COMPOSITE BLACK 1 REF LOOP TRI/BLACK 2 TRI/BLACK 3 TRI/BLACK 4 SDI 1 SDI 1 BLACK SDI 2
Backup SRG-4400
GPI/RS232
100-BaseT
GPS 1Hz 10MHz IN 10MHz WK/TTL1 WK/TTL2 6Hz/TTL3 DARS AES 1 AES 2
SDI 2 BLACK
BALANCED AUDIO/AES/LTC
COMPOSITE BLACK 1 REF LOOP TRI/BLACK 2 TRI/BLACK 3 TRI/BLACK 4 SDI 1 SDI 1 BLACK SDI 2
4400CR-100-01
4400CR-100-01