40
English
Starting up the grill before barbecuing for the first time
Ensure that all previous points are observed and a gas-tight connection is established at the gas grill.
Remove the visible labels.
Before starting up, check whether the burners are installed in the correct position. See „Re-
moving the burners“ auf Seite 48“.
Before you use the appliance for the first time, we recommend that you "season" it to remove any residues
from the production process.
Mains connection
1. Ensure that the mains voltage corresponds to the required operating voltage of the power supply unit
before you insert it in the wall socket. Check the details on the rating plate.
2. Connect the device to the mains power supply (230 V~, 50 Hz) using the power supply unit provided.
3. Switch on the lights by pressing switch 13.
"Seasoning" process
1. Before seasoning the appliance, please remove any stickers on the lid window and the side burner.
2. If you do not do so, the stickers may melt when the appliance heats up and will then be very difficult to
remove.
3. Take out the grates and wash them with a mild detergent.
4. Refit the components.
5. Switch the grill on, start all main burners and allow it to heat up with the lid down for approx. 30 minu-
tes.
6. After the seasoning phase, switch the appliance off.
Lighting the burners
Jet Flame igniter system
When the burner control is turned to the lighting position you will hear a
click from the Jet Flame igniter system.
Lighting procedure:
1. Open the lid before lighting the grill.
2. Before starting the lighting procedure, all control knobs must be set to the position "OFF".
3. Open the valve at the gas cylinder.
4. Press the right-hand control knob 6 inwards and turn it slowly anti-clockwise to the "MAX" position or
until you hear the click of the Jet Flame ignition system. That initiates the ignition spark.
5. If the burner does not light immediately, turn the control knob back to "OFF", wait 1 minute to allow
the accumulated gas to disperse and then repeat the lighting procedure.
6. Repeat this process until all the burners are lit or until you have lit all the burners you wish to use.
7. You can now use the control knob to adjust the flame to suit your particular requirements. For the lo-
west setting, you turn the control knob anti-clockwise to "MIN".
8. If you do not succeed in lighting the grill, refer to the section headed "Troubleshooting" on page 50.
Lighting manually
• In exceptional cases, the grill can also be lit with a match.
• To do so, use a match that is at least 90 mm long and insert the
burning match through the lighting hole on the right.
Turning off the burners
Press in the control knob (gas valve) for the burner concerned and
turn it clockwise to "OFF".
Always turn off the gas supply at the cylinder after barbe-
cuing.
