OVERVIEW
8
ULTRACONSOLE USERS MANUAL
If an expansion card is permanently removed, a terminator and cover
plate must be installed.
Figure 1. Expansion card
To remove the expansion card and install/remove jumper JP1:
1. Remove power from the UltraConsole switch.
2. Remove any expansion cables.
3. Unscrew the two screws securing the expansion card to the
chassis.
4. Carefully pull the expansion card straight back until it unseats
from the backplane connector.
5. Remove/install the jumper JP1, on the expansion cards.
6. Re-install the expansion card. Make sure it seats properly in the
backplane connector.
7. Secure the expansion card with the two screws.
8. Replace any expansion cables
RS232 port
All UltraConsole switches are equipped with an RS232 serial port. This
port on all models is an RJ12, 6-conductor connector. It provides a
serial interface to the UltraConsole from a computer terminal, a
standalone computer or a Notebook computer that is not connected to
a CPU port on the Unit. The RS232 serial port enables you to:
Upgrade the system firmware
Restore a Unit to its factory default settings
Configure an expansion switch
Switch a KVM station to a CPU port
An adapter and serial cable are provided for serial interface.
Firmware cannot be updated from a computer terminal.
IN
OUT
JP1