1 What's New
1 What's New
Note:
The software and firmware versions installed on your crowdbeamer device can be seen
in the Status page of the
(page 25).
Firmware version v2017.08.25
Fixes:
• Improved battery status notification when device is turned off.
• New device configuration options are merged properly with existing ones during firmware
upgrades.
• Better ESD resistance against occasional OLED freezes and rolling screen effect.
• The automatic detection of the RGB colorspace works correctly.
• The "Bye" message no longer gets stuck on the OLED after powering the device off.
Improvements:
• On the Web Interface:
• Output resolution options are sorted in numerical order.
• Mouseover help tooltips.
• Factory reset button (on the
(page 29)) to restore the device to
the initial state.
• Display of the device's current temperature.
• Display of the built in fan's current speed.
• The device's IP address is shown on the OLED.
• The registered state of the device is retained after a
(page 12).
• Preferred input resolution is now 1920x1080p30.
• Automatic frame rate adjustment to ensure smoother playback.
• Use RGB888 on the output whenever possible.
• The fan now stops every time the device enters sleep mode.
New features:
• System can be restored from the
(page 12) in case of failure.
• Programmable device button
• When the button's function is set to "Generate new WiFi key" the WPA2 protection is turned on
automatically.
• When the button's function is set to "Generate new WiFi key" the user is warned that
reconnection with the newly generated key will be necessary.
Firmware version v2017.06.27
New user operations:
(page 30).
• To set an
(page 31) which is useful if the device is not in an easily accessible
position.
• To select the operation performed when the
power button on the device is pressed
(page 30).
(page 30) that can be used by support staff.
(page 27) when using Apple devices through some splitters.
4
crowdbeamer device manual
Version 1.2
©
RORYCO NV Last updated 2017-08-26
