RORYCO Crowdbeamer, Device Manual

Page: 29 / 32

5 Configure crowdbeamer
Channel
Allows you to select a specific channel if required (from a list of those allowed worldwide).
The value of
0
results in auto-selection of the channels upon booting up crowdbeamer.
Wireless IP address of device
This field displays the current IP address of the device. This address is also shown in the OLED
display.
You can modify the third group of numbers in the IP address. You can enter a number in the range
0
to
254
that is a multiple of 4.
Encryption
The default setting for the encryption is "Open", which means that no password is required to
access the private crowdbeamer WiFi network.
To set a password to access the network (page
29).
WiFi security key
The field in which the network access password is set.
To set a password to access the network (page 29)
Save
Saves the changes made on this page.
To set a password to access the network
1. Click on
WPA2
.
2. Enter a password in the
WiFi security key
field.
Note: Your password must include a minimum of 8 characters . It is recommended that
you use a "strong" password i.e. at least 8 characters which includes upper and lower case
letters as well as numbers and other keyboard characters arranged randomly.
3. Click [Save].
The password appears in the OLED display on the device (if the required option has been set on the
System configuration page (page 30)).
Note: You can also generate a new WiFi security key (page 31) by setting an option on the
System page.
5.4 The System page
Note:
The first time you click on one of the Video, Network or System pages, you will be asked for a
password.
Username: admin
Password: this is set when the device is activated.
To change the admin password (page 29).
SW version
The current version of the installed software.
FW version
The current firmware version. See also Upgrading the firmware (page 14).
crowdbeamer device manual Version 1.2
©
RORYCO NV Published 2017-07-15 29