Page 19
9.
Performance test
After installation and prior to use all functions of Flexi must be tested. The test must be carried out
by competent personnel. Subsequently the test shall be carried out at least once a year:
Testing prior to connection of mains voltage:
1. Check that the mounting instructions have been observed.
2. Check that all bolts have been tightened.
3. Check that all cables have been connected correctly and that the plugs have been pressed
home.
4. Check that there is no load on the Flexi frame.
5. Check that there is nothing preventing the Flexi from moving freely within the height
adjustment range.
Start-up Procedure
1. Connect the net cable and turn on the power
2. Connect the motor cables to M1 and M2
3. Connect the control switch to HS
4. Press DOWN on the control switch, move the frame to bottom position, check that the
movement is even and smooth. Make sure that the hose connections follow the movement
of the frame and that they do not get squeezed. The frame is now reset.
5. Press UP on the control switch, move the frame to top position and check that the
movement is even and smooth. Make sure that the hose connections follow the movement
of the frame and that they do not get squeezed.
If a safety strip has been mounted under the Flexi frame it must be tested as follows:
Press DOWN on the control switch and let the Flexi frame move 2-5 cm downward. Now
activate the safety strip by pressing it lightly. The frame must stop the downward movement,
move 1-2 cm upward and stop.
If a safety strip and smartbox2
has been fitted above the frame, e.g. on a wall cupboard ”Diagonal”,
this must also be tested as follows:
Make sure that the Flexi frame is in the bottom position. Press UP on the button and let the
frame move 2-5 cm upward. Now the safety strip above the Flexi frame will be activated. The
Flexi frame must now stop its UPWARD movement and move 1-2 cm downward and stop.
If all these tests are ok, the Flexi frame is ready for use. Se section 12
“Safety in use”.
