Page 16
8.
Mounting of accessories
8.1 Mounting the supporting feet
8.2 Mounting the covers for the legs
8.3 Mounting the press pad for disabled persons
8.1.1
Remove the adjusting screw of
the leg.
8.1.2
Fit the foot and the extension to the
leg with the screws provided and
tighten the screws.
8.2.1
Press the covers, consisting
of an inside and an outside
cover, carefully over the leg.
8.2.2
Lift up the upper/outside cover and
press the snap lock into the hole of
the leg. It is important to pull the
snap lock completely out prior to
mounting. Now press in the snap
lock to lock it.
8.3.1
The press pad for height
adjustment must be placed in the
wooden front fascia
.
It consists
of a press pad contact and a 150
cm long cable provided with a
DIN-plug.
The press pad and the cable are
delivered as one unit ready for
mounting.
Drill holes as illustrated to suit the
required position.
8.3.2
Fit the press pad by pulling the
cable through the large hole and
fasten it in the small holes by
means of the M6 nuts provided.
