ROME TRCW-20, Operator'S Manual

Page: 58 / 66

58
ASSEMBLY
STEP 2: INSTALLING GANGS ON GANG
CARRIERS
Where lifting facilities are available:
A. Position front gang assembly with concave
side of discs to right, as viewed from the
rear.
B. Position rear gang assembly with concave
side of discs to left, as viewed from the rear.
C. Place gang carriers on corresponding gang
assemblies and attach to bearing standards
with the bearing hex bolts, hex jam nuts,
hex nuts, and bearing wear plates.
Where lifting facilities are limited:
A. Position gang carriers upside down. Place
gang assemblies on gang carriers and
attach to bearing standards with the bearing
hex bolts, hex jam nuts, hex nut, and
bearing wear plates.
B. Turn completed assemblies of gangs and
gang carriers right side up.
C. Install disc scrapers.
STEP 3: INSTALLING GANG CARRIERS TO
FRAME
Place the gang carriers in approximately the correct
position on a flat surface and securely block them
in an upright position. Place the frame on top of the
gang carriers and bolt in place with hex nuts
provided.
Note: Place flat washers against all
slotted holes. Inserting the pivot bolts first facilitates
easy assembly. Gangs may then be provided to the
desired angle beneath the frame and bolted in
place with appropriate hardware.
STEP 4: INSTALLING TRANSPORT ASSEMBLY
The transport assembly is attached to the frame
with two bearing assemblies. These slide onto the
transport and then bolt onto the frame. The
transport should be facing the rear of the unit when
attached onto the frame. This orientation allows the
wheels to pivot down and towards the front of the
disc harrow.
Note: For domestic shipment the
transport will be mounted onto the frame assembly.