Setup of Sheet Media
Load the sheet media on the printer. When the loading is finished, [Output possible.] is displayed as the
status. This work is referred to as "Setup of Media."
1. A: Determine the positions of the media.
When using transparent media, whose edges cannot be detected, and when [Preferences]>[Media Edge
Detection] is set to [Disable], the suction fan does not activate, so media cannot be loaded with this pro-
cedure. In these cases, refer to
1. B: Determine the positions of the media ([Media Edge Detection]:
By default, [Skewing Correction Support at Setup] is set to [Enable].
Procedure
1.
Tap
on the operation panel.
The sub power is switched on.
2.
Open the front cover.
3.
Move the media clamps to the outside of the grit rollers on the left and right edges respectively.
4.
(Move to the rear of the printer.) Release the locking mechanisms of the media holders, and then draw
them to the left and right ends respectively.
Setup of New Media
Basic Operations
53
Summary of Contents for TrueVIS SG3-300
