Roland SP-300i, User Manual

Page: 98 / 134

4-9 Performing Printing and Cutting Separately
96
4
Feature Reference
Aligning Automatically and Cutting
When you make the setting for reading crop marks when sending cutting data from the computer, alignment is performed
with the presence or absence of crop marks determined automatically.
For information on how to make the setting, refer to the documentation for the software RIP you're using.
Procedure

Load the media.
Angled no more than 5 degrees.
Otherwise alignment becomes impossible.

Send the cutting data.
Alignment is performed automatically, then cutting starts.
If Automatic Alignment Cannot Be Performed
If the machine fails to detect the crop marks, the screen shown in the figure appears
and operation stops.
If this happens, press
, then take action as follows.

Reload the media, then send the data again.

If this does not resolve the problem, then perform alignment manually.
 P. 97, "Aligning Manually and Cutting"
CROPMARK ERROR
NOT FOUND
Crop marks
Blade protection
5 degrees
or more
5 degrees
or more