81
4 Adjustment
4
1
Make sure to check the followings before this adjustment.
1. Put LINE SPACING MODE to default. (P.95)
2. GRIT CALIBRATION
3. Turn off the FRONT EDGE SENSE MODE. (P.94)
2
3
Set the CYAN RIBBON CARTRIDGE and MEDIA on the
machine. And then, select ROLL as media type.
4
Other RIBBON CARTRIDGE except the CYAN
can not be used.
For selection
To enter
Raise the SHEET LOADING LEVER.
Turn on the MAIN POWER SW while pressing [POWER],
[SHEET TYPE] and [BASE POINT] keys and enter the
FACTORY MODE.
Select [CARTRIDGE HOLDER 4] with [
] or [
] keys
and press [SHEET TYPE] key to enter the GRIT
ECCENTRICITY ADJUSTMENT MODE.
Lower the SHEET LOADING LEVER and close the
FRONT COVER.
The pattern shown in the figure will be printed.
17 BANDs
30mm
17 BANDs
30mm
Because there is no STITCHING TREATMENT,
there will be gap or banding between bands.
Summary of Contents for Color Camm Pro PC-60
Page 4: ... MEMO ...
Page 6: ...2 1 Structure Spare Parts 1 1 2 FRAME 1 ...
Page 8: ...4 1 Structure Spare Parts 1 1 3 FRAME 2 ...
Page 88: ...84 4 Adjustment 4 MEMO ...
