23
Roll material must be placed at a
predetermined shaft position.
Failure to do so may
result in falling of the
roll, leading to injury.
Acceptable material widths
CJ-500:
90 to 1371 mm (3-9/16 to 54 in.)
CJ-400:
90 to 1117 mm (3-9/16 to 44 in.)
* However, when loading material with a width
of 90 to 430 mm (3-9/16 to 17 in.), set the
[EDGE SENSE] menu item to [DISABLE].
Pass the stoppers onto both ends of the shaft.
(The shafts (2 pieces), stoppers (2 pieces), and screws
(2 pieces) are included with the stand.)
* When passing the shaft through the stopper,
be sure to loosen the screws on the stopper
first.
1
Loading Roll Material
Align the media flange with the roll sheet edges, matching the roll sheet center ID.
(The media flange is included with the stand.)
2
1 Loading the Material
Stopper
Tighten loosely with the screws.
Shaft
Media flange
Media flange
50.8 mm
(2 in.)
76.2 mm
(3 in.)
Setup for Printing
Setup for Printing
Media flange
Summary of Contents for CammJet CJ-400
Page 12: ...10 MEMO...
Page 97: ...R3 010214...
