26
Pass the material between the pinch rollers and the grit
rollers as shown in the figure.
1
Move the sheet loading lever toward LOAD.
The pinch rollers lower to hold the material in place.
3
Close the front cover.
Use the [
] and [
] keys to select [PIECE], then
press the [ENTER] key.
4
Loading Flat Material
Refer to steps 5 and 6 in "Loading Roll Material," and
position the material and the pinch rollers correctly.
2
- When loading flat material, if the material touches the shaft or roll material at the back of the machine, remove the
shaft and roll material.
- When thick material is loaded, it may adjust the head height. For more information, see "User's Reference --
Adjusting the Height of the Printing Head."
- When changed to a different type of material, it is necessary to carry out feed correction and bidirectional correc-
tion. For more information, see "User's Reference -- Making Corrections for Printing."
- If the sides of the material have warped, then bend back the warp or feed the warped portion to the front and
perform setup again. Performing printing with a warped piece of material may cause head smudging or jamming of
the material. If the printing heads become damaged or soiled as a result, printing accuracy may suffer.
Press the [SETUP] key. This detects the width and
length of the material and shows the printable width
and length on the display.
5
If a pinch roller is positioned over an area where is no
grit roller, the massage shown at below appears when
you press the [SETUP] key.
PINCHROLL ERROR
INVALID LEFTPOS
or [RIGHT]
Top menu
W1000mm L1230mm
FINE BI-DIR
*If the material is misaligned and looks like it might
come loose from the pinch rollers, or actually does
come loose, please reload the material.
Pass the material
Setup for Printing
Check the positioning of the pinch rollers and
make sure they are aligned at the correct positions.
The SETUP LED lights up
SETUP SHEET
ROLL EDGE PIECE
If [PIECE] does not appear, set [EDGE SENSE]
to [ENABLE].
Sheet loading lever
When moved partway,
only the right-hand
pinch roller descends.
Data cannot be output
while in this state. To
secure the material in
place, move all the way
to "LOAD."
Summary of Contents for CammJet CJ-400
Page 12: ...10 MEMO...
Page 97: ...R3 010214...
