60
User's Reference
When printing is finished press the [SET UP] key,
remove the material and carry out lamination (or
whatever further processing needs to be done).
Load the material at the same pinch-roller positions
used during printing, then press the [SETUP] key.
At this time, load the material so that the crop marks
are to the inner sides of the pinch rollers on either side.
2
Follow steps 1 through 4 for making the setting
automatically on the previous pages, then perform
printing.
1
Adjusting Manually
Install a blade on the cutting carriage.
3
Set the base point.
Use the arrow keys to align the center of the blade at
the location on the crop mark shown in the figure, then
press the [BASE POINT] key.
4
Set the align point.
Use the arrow keys to align the center of the blade at
the place on the lower-left or upper-right crop mark
shown in the figure, then press the [ALIGN POINT]
key.
When an upper-right align point is set at a crop mark,
the correction value set with the [CUTTING ADJ.]
menu is ignored.
5
Base point
Center of the
blade
Send the cutting data from the computer.
6
Align point
Align point
Center of the
blade
Center of the
blade
Align the
center of
the blade
with the
base point
or the align
point.
*The align point cannot be set to both the lower left and upper right points.
*The left and right crop marks are tilted 5 degrees or more with respect to the
direction of carriage movement
(or the left and right crop marks are displaced by 20 mm (13/16 in.) or more in
the sheet-feed direction)
*Crop marks and the like drawn with computer programs cannot be used as crop
marks by this machine.
Summary of Contents for CammJet CJ-400
Page 12: ...10 MEMO...
Page 97: ...R3 010214...
