67
User's Reference
About the Prefeed ([PREFEED]) Function
When using roll material, you can check in advance whether there is enough material available for the amount of printing or cutting data,
or whether the material can be gripped correctly.
When data is sent from the computer, the amount of material equal to the length of the data is automatically pulled out, and then printing
or cutting begins. If material equal to the amount of data is not available, operation pauses and the following message appears on the
display.
SHEET TOO SHORT
CONTINUE?
Press the [ENTER] key to perform printing or cutting.
To cancel output, stop sending data from the computer, then hold down the [SETUP] key
for 2 to 3 seconds.
When shipped from the factory, the prefeed ([PREFEED]) function is set to [ENABLE] as the default.
When using an optionally available media take-up unit (the TU-500/400), set the prefeed ([PREFEED]) function to
[DISABLE].
Summary of Contents for CammJet CJ-400
Page 12: ...10 MEMO...
Page 97: ...R3 010214...
