30
When viewed from the front, align so that the left-
hand edge of the material is above any of the grit
rollers and the right-hand edge is above the long grit
roller.
5
Set the two shafts in place and apply the brake.
3
Place the rolled material on the shaft.
Pass the end of the material between the pinch rollers
and the grit rollers so that it extends from the front of
the unit.
4
Align the orientation of the material so that it is
perfectly straight, and move the left-hand and right-
hand pinch rollers so that they are above the grit
rollers.
Position the middle pinch roller over the grit roller that
lies between the left- and right-hand pinch rollers.
6
Rear
* Position the left and right
pinch rollers over the material,
near the edges.
Grit rollers
Grit roller
(Right)
Rail
Pinch roller (middle)
Pinch roller (right)
Pinch roller (left)
Shafts
Setup for Cutting
Brake
* The white stickers on the rail portion are
guides for positioning the grit rollers.
* Make sure that the right-
hand edge of the material
does not extend beyond
the right-hand edge of the
grit roller.
* Pull out the material
until it engages the
sensor.
Rear
Roll material
Summary of Contents for CammJet CJ-400
Page 12: ...10 MEMO...
Page 97: ...R3 010214...
