Roland CAMM SCRIBE CS-20, User Manual

Page: 17 / 28

9
For Cutting
* Use SELECT key to choose "CUTTER" as the mode.
1
Insert the blade into the blade holder until it snaps
into place with an audible click.
For fine adjustment of
the blade tip, turn the
lower part of the blade
holder.
The tool can be removed
by pressing the push-pin.
For Pen Plotting
* Use SELECT key to choose "PEN (SCORE)" as the mode.
2
Loosen the tool mounting screw and insert the tool
adapter into the tool carriage.
Retighten the tool mounting
screw to secure in place.
1
Insert the pen into the tool adapter, insert the spring
that comes with the tool adapter, then attach the cap.
Tool adapter
* If the depth regulator nose is
installed, it should be removed.
* The spacer
is not used.
Pen
* The pen uses indelible ink and
can rapidly dry out. Be sure to
cap the pen when not in use.
Cap
Spring
Do not drop or damage the blade holder. Damage to the blade holder may impede its movement within the tool adapter.
Remove the cap.
Push-pin
2
Insert the blade holder into the tool adapter. Then, depending on the thickness of the material to be cut, insert the
spacer or spring included with the tool adapted, or attach the cap without inserting either the spacer or the spring.
Spacer
Spring
None
Cutting force
1 kgf
Fluorescent and
reflective sheets, etc.
Cutting force
80 gf
Sheets for indoor/
outdoor use, etc.
Cutting force
35 gf
Sheets for outdoor
use, etc.
Cap
Blade holder
Tool adapter
* Select in order of "
Spacer
" , "
Spring
" and "
None
" when thinner the material becomes.