Roland CAMM SCRIBE CS-20, User Manual

Page: 14 / 28

6
6 Before Starting to Cut and Plot
Loading the Material
If the material is not secured correctly, it may not be cut and plot as intended.
Some examples of material loading are shown below. Refer to these to use the appropriate method for the material at hand to
secure it in place.
* Be sure that the tool carriage is at the VIEW position ( inner right-hand side ) before loading material.
ENGRAVER ********** ********** ********** CUTTER ********** **********
CUTTER ********** ********** PEN ENGRAVER
SCORE
SCORE **********
Adhesive sheet for
securing material
Double-sided
tape
Bottom of the
material
Adhesive tape
Cut a border and
peel it off.
Using the included adhesive sheet... Peel off the edges from the back of the
sheet material...
Using commercially available
double-sided tape... Using commercially available
adhesive tape...
Material
Adhesive area
Sheet material
CUTTER