3
Control Panel
r.p.m knob
This sets the spindle
speed (in rpm).
SPEED knob
This sets the cutting
or plotting speed.
SELECT key
This selects the cutting or plotting mode.
The LED for the selected mode lights up.
5. Load the material and install the tool.
6. Set the origin point.
7. Set the cutting conditions (test cut).
10. Switch off the power.
11. Clean up.
4. Switch on the power to the CAMM SCRIBE.
2. Install the driver software and set up the interface.
3. Use a software application to create the data.
1. Install and connect the computer and the CAMM SCRIBE.
Follow the steps shown below to work with materials on the CAMM SCRIBE.
4 Task Flow
9. End operations.
8. Send the data from the computer to perform machining.
SET SURFACE / TEST key
Pressed briefly:
When the character cutter has been installed, this moves the tool up or down.
Held down for one second or longer:
Performs test cutting.
PAUSE / VIEW key
Pressed briefly:
Pauses operation.
Held down for two seconds or longer:
Moves the tool carriage to the rear right (the
VIEW position) and pauses operation.
The functions of these keys
differ depending on whether
the key is pressed briefly
and immediately released or
held down for a certain
length of time.
ORIGIN POINT / SET ORIGIN POINT key
Pressed briefly:
Moves the tool carriage to the origin point.
Held down for two seconds or longer:
Makes the present position of the tool carriage the
origin point.
Held down
Pressed
briefly
These are used to move the tool carriage in the direction of the arrow.
Hold down the key for faster movement.
ARROW keys
Summary of Contents for CAMM SCRIBE CS-20
Page 26: ...18 Appendix C Specifications...
Page 28: ...R8 001101 CS 20...
