Connecting the Probe to the DUT
R&S
®
RT
‑
ZM
34
User Manual 1419.3128.02 ─ 04
The R&S
RT-ZMA50 extreme temperature kit is
well suited for creating solid contact with test
points in extreme temperature areas, e.g. tem-
perature chambers.
Note
: The R&S
RT-ZM probe amplifier always
remains outside the temperature chamber and
has a specified operating temperature range
from 0°C to 40°C.
Bandwidth: up to 12 GHz
MultiMode compatible
Length: 115 cm
Variable span range of the leads: 0 mm to 5 mm
(0 mil to 200 mil)
Temperature range: -55°
C to +125°
C
The R&S
RT-ZMA11 tip cable solder-in ET can-
not be plugged directly into the probe amplifier.
Always connect the R&S
RT-ZMA11 tip cable
solder-in ET to the 1-m extension cable pair and
connect the other end of the extension cable
pair to the R&S
RT-ZM probe amplifier.
For measurements with MultiMode functionality,
solder both signal wires (P,N) and both ground
wires (GND) at the outside of the tip board to the
DUT.
In this configuration, you can measure single-
ended, differential and common mode signals.
If you want to use the DM mode only for differ-
ential measurements, you do not have to solder
the ground wires (GND).
Always keep soldered leads as short as possible
for best performance and signal integrity.
R&S
RT-ZMA50 Extreme Temperature Kit
