Connecting the Probe to the DUT
R&S
®
RT
‑
ZM
30
User Manual 1419.3128.02 ─ 04
The R&S
RT-ZMA15 tip cable quick connect is
suited for creating contact with soldered-in
270
Ω
resistors, and easily reconnecting dif-
ferent test points.
Only use the 270
Ω
resistors from the
R&S
RT-ZMA accessories set for optimal flat-
ness and bandwidth
Bandwidth: up to 12 GHz
MultiMode compatible
Length: 15 cm
Distance range: 1.27 mm (50 mil)
Temperature range: -30°C to +80°C
Permanently solder the 270
Ω
resistors (P,N)
and ground wire (GND) to your DUT and
effortlessly connect or reconnect your socket
head to your measurement point. In this con-
figuration, you can measure single-ended, dif-
ferential and common mode signals.
However, if you are making only differential
measurements you do not have to solder the
ground wire (GND) between the two resistors.
Always keep soldered pins and resistors as
short as possible for best performance and
signal integrity.
3.5
R&S
RT-ZMA30 Browser Module
The R&S
RT-ZMA30 browser module allows handheld probing with maximum
convenience at the DUT and supports the full bandwidth of the probe amplifier.
R&S
RT-ZMA30 Browser Module
