Connecting the Probe to the DUT
R&S
®
RT
‑
ZM
32
User Manual 1419.3128.02 ─ 04
Replaceable parts, spring-loaded resistor tips
Risk of damage due to excess force
To avoid damaging the browser’s pins, do not apply a side load to the
browser.
Do not apply too much force when browsing. The weight of the probe in
your hand should be sufficient.
Always remove the browser from the DUT before disconnecting the probe ampli-
fier from the oscilloscope.
3.6
R&S
RT-ZMA40 SMA Module
The R&S
RT-ZMA40 SMA module allows you to connect two 2.92
mm, 3.5
mm,
or SMA cables to make a MultiMode measurement on a single oscilloscope chan-
nel. It supports the full bandwidth of the probe amplifier.
When connecting the SMA module to the output sockets of the DUT, use the S-
shaped semi-rigid cables supplied with the SMA module. Change the angle of the
S-shaped semi-rigid cables to adjust the distance of the input sockets. The S-sha-
ped semi-rigid cables are phase-matched to prevent unwanted signal conversion
and assure best signal integrity.
Always remove the SMA module from the DUT before disconnecting the probe
amplifier from the oscilloscope.
R&S
RT-ZMA40 SMA Module
