Roger PRT MF Series, Operating Manual, Page: 42 / 54

PRTxxMF series readers Operating Manual.doc 2019-01-29
42/54
1 1 . I
N S T A L L A T I O N
G
U I D E L I N E S
 Reader should be installed in such way as to ensure physical access to the connection
cable, screw terminals and programming jumpers.
 Before the reader will be mounted in desired location it is recommended to configure its
operating mode and if required to program the MASTER and INSTALLER users.
 Any MIFARE proximity card can be programmed as MASTER or INSTALLER card.
 When lost or stolen a new MASTER and INSTALLER cards (PIN-s) can be reprogrammed in
the reader.
 When the reader has been set for Terminal Mode (online unit connected to the host
controller), programming of MASTER and INSTALLER users can be skipped.
 A new factory delivered unit is configured with [000] Online mode, RACS address
ID=0 .
 The reader should be mounted near the supervised door on a vertical piece of supporting
structure.
 Disconnect power supply before making any electrical connections.
 Be aware that the installation of reader directly on the metal type surface will reduce card
reading distance.
 For installations on a metal surface you can place a non-metallic 10 mm thick spacer (a
plastic/plaster plate etc.) between the reader and the supporting structure.
 For installations with two readers to be mounted on the opposite sides of the same wall and
aligned along the same geometrical axis, place a metal plate between them and make sure
none of two readers has direct contact with it (allow min. 10 mm space). Be aware that the
reading distance will be reduced.
 For best results mount the proximity readers at least 0.5 m apart.
 When using separate power supply sources, short all power supply negatives (ground).
 It is recommended to ground the negative power supply line (only at one point).