Roger PRT MF Series, Operating Manual, Page: 24 / 54

PRTxxMF series readers Operating Manual.doc 2019-01-29
24/54
secondary (slave) reader. The LED/buzzer signals occur simultaneously on both readers (primary
and secondary). Both readers must have the same supply minus. It is not required to disconnect
the XM-2 expander from system being currently programmed.
6.2. P
ROGRAMMING VIA
M
EMORY
C
ARD
The configuration settings of the reader can be exported to and imported from a special Memory
Card ( M-Card ). The M-Card is the standard MIFARE 4k proximity card specially formatted by the
RARC program for this purpose. Reader settings can be exported to M-Card from a reader or from
the RARC program. Also, the reader settings saved on the M-Card can be imported directly from
M-Card to the reader or to the RARC program.
Note: The communication between RARC program and Memory Card can be provided through any
PRTxxMF series reader connected to the PC.
The entire settings of the reader can be divided into three parts:
 User settings
 Installer settings
 Configuration settings (complete)
The Configuration settings refers to all parameters programmed into a reader (card, PIN-s and
all other data). The Users settings refers to settings which are solely related with users (cards
and PIN-s) while Installer settings refers to the rest of reader settings (i.e. all configuration data
except cards and PIN-s). Following rule applies:
Configuration settings = User se Installer settings
6.2.1. Importing Configuration Settings from the Memory Card
This procedure imports reader settings (Users Data + Installer Data) from the Memory Card.
 Switch power supply off
 Remove all connections from CLK and DTA lines
 Connect CLK to DTA
 Switch power on
 Wait till LED SYSTEM is on
 Wile LED SYSTEM is on disconnect CLK from DTA
 Wait till LED STATUS starts blinking red
 While LED STATUS is blinking red place M-Card very close to the front of the reader
and keep it in this position
 Once LED STATUS stops blinking remove the M-Card, reader will make restart and
then will enter normal operation with new settings imported from the M-Card
6.2.2. Exporting Configuration Settings to the Memory Card
This procedure exports reader settings (Users Data + Installer Data) to the Memory Card.
 Switch power supply off
 Remove all connections from CLK and DTA lines
 Connect CLK to DTA
 Switch power on
 Wait till LED SYSTEM is on
 Wile LED SYSTEM is on disconnect CLK from DTA
 Wait till LED STATUS starts blinking green
 While LED STATUS is blinking green place M-Card very close to the front of the
reader and keep it in this position
 Once LED STATUS stops blinking remove the M-Card, reader will make restart and
then will enter normal operation, the Configuration Settings from the reader were
exported to the M-Card
6.2.3. Importing Users Data from Memory Card
This procedure imports Users Data (cards and PIN-s) from the Memory Card.