Roger PRT MF Series, Operating Manual, Page: 38 / 54

PRTxxMF series readers Operating Manual.doc 2019-01-29
38/54
The reader searches its memory for the presented card. Once successful it removes it from the
memory and the record previously occupied by this card is released. This command removes only
card, if the user has PIN then it still can be used.
[23][ID] – Delete a user with given ID
A user with entered ID is deleted (both his card and his PIN are removed), a new user can be
programmed to use this ID index.
[24][YYMMDDhhmm] – Setting date and time
Where: YY – two last digits of year (00-99), MM – month (01-12), DD – day (01-31), hh – hour
(00-23), mm – minute (00-59)
[#] – Exit from User Programming Mode
After exiting from the User Programming mode reader returns to either armed or disarmed mode
depending on which one was set prior to User Programming Mode.
Programming Examples
Example 1: Add a new TOGGLE LTD user with a card; programming sequence: [1][8][Card][#] or
[1][8][Card][Wait ~10s or press [#]]
 Read your MASTER card or enter MASTER PIN
 The reader enters User Programming mode (LED OPEN is on and LED STATUS is
on and red)
 Press [1][8]
 LED SYSTEM starts flashing
 Present a card which you want assign for a new TOGGLE LTD user
 Press [#], command is completed
The reader has completed programming function, however, it has not left User Programming mode
so now you can enter another programming command.
Example 2: Delete a user with ID=45; programming sequence: [2][3][0][4][5]
 Read your MASTER card or enter MASTER PIN if you are not in User Programming mode
 The reader enters User Programming mode (LED OPEN is on and its LED STATUS
is on and red)
 Press [2][3]
 LED SYSTEM starts flashing
 Press [0]
 Press [4]
 Press [5]
 Press [#], command is completed
The user with ID=45 has been deleted, reader still remains in User Programming mode, so now
you can enter another programming command.
1 0 . P
R O G R A M M I N G
F
R O M
P C
The reder can be fully programmed from the PC through standard COM port (RS232) or via
dedicated RUD-1 interface (USB port). In both cases the RARC program is required. In order to
establish the connection, select
Options->Port command in RARC software, then Connection-
>Connect…, the option RS232 and then the button Start.
10.1. P
ROGRAMMING VIA
RS232 COM
PORT
In this scenario connection between programmed reader and PC requires four wires: GND, RXD,
TXD and RTS as presented on the drawing below. The reader must be supplied from the external
source of power.