23
C r e s c e n d o S e t
C r e s c e n d o S e t
S T A G E :
M o d e A L T
1
C r e s c e n d o S e t
C r e s c e n d o S e t
S T A G E :
M o d e S T D
1
To program a new Crescendo sequence:
1. Select the Crescendo sequence to be programmed:
•
For Standard Crescendo, make sure
ALT CRESC
piston is unlit
•
For Alternate Crescendo, make sure
ALT CRESC
piston is lit
2. Press and hold the
SET
piston.
3. Press
the
ALT CRESC
piston. The piston flashes, and the display shows one of
the following screens:
Standard Crescendo
Alternate Crescendo
4. The stops and couplers currently set on stage 1 are selected.
5. Make changes to stage 1, if desired, and press
SET
to proceed to stage 2.
6. Add or subtract stops at each stage as desired and press
SET
to step to next stage.
Continue this step until you reach the end of the sequence or you’re finished
making stop changes. Remember:
•
to
add
a stop or combination of stops to the sequence, go to the desired
stage, select them and press
SET
•
to
delete
a stop or combination of stops from the sequence, go to the
first
stage in which the stop or stops are activated, turn them off, and press
SET
•
to proceed to the next stage without adding or subtracting stops or
couplers, simply press
SET
7. The current sequence may be viewed by advancing through the stages one at a
time using the Alpha dial. At each stage, the stage number (1 to 63) is indicated
in the Console Display, and the stops and couplers set at the selected stage turn
on.
8. To clear the entire Crescendo sequence (stages 1 through 63), hold
SET
and press
General Cancel (‘
0
’). This erases the sequence and resets the current stage
number to 1 so that a new sequence can be entered.
9. To exit the Crescendo Set Mode menu at any time, press General Cancel (‘
0
’).
Any changes in the sequence made up to that point are saved.
