ROBWAY RCI-4100, Operation And Installation, Page: 57 / 187

OPERATION AND INSTALLATION
RCI-4100 SYSTEM
MAN-1111 Rev H ©Copyright 2015 LSI-Robway Pty Ltd Page 57
To test the function, lower either one of the hook blocks on the deck or platform until the rope gets
slack and the rope is hoisting up. When the load equals or is less than the appropriate value, the word
“SLACK” appears in the “LOAD” window and the appropriate digital output changes state.
Reference the applicable drawing(s) in the RCI System Configuration Documents in
Attachments.
CAUTION: PLEASE NOTE THAT ALL INDUCTIVE LOADS SUCH AS RELAYS AND
SOLENOIDS REQUIRE SNUBBER DIODES FOR TRANSIENT SUPPRESSION.
7.5. Post Calibration Checks
After completing the calibration check all functions of the RCI-4100 including:
•
Displayed radius for accuracy.
•
Lift some test weights on main and aux winches to ensure accuracy.
•
Test all digital inputs.
•
Test all digital outputs before connection to crane
•
Test all relay outputs before connection to crane.
•
Check slew position and that the slew reset is working (if applicable).
•
Set restricted slew zones (if applicable).
•
Check wind speed sensor operation (if applicable).
•
Check any other sensors used by the RCI-4100 system.
•
Record Calibration Data:
o
After calibrating the sensors the calibration data should be recorded (manually, using
pen and paper) for service records by accessing function code F-xx “Alter Calibration
Data”.
o
Refer to Section 6.17 Copying and Restoring Calibration Data for details and
procedure.