54
The Comfort Control Panel’s power cord must be type tipo FG7 3Gx2.5mm
1.
2
. the
power supply is 230V AC 1N 50Hz.
Cut a suitable length of cable.
2.
The cable must be connected to the terminal block on the bottom right of the
3.
Comfort Control Panel. First make a hole in the electrical cabinet near to the termi-
nal block and pass the cable through it.
Connect the cable to the terminal block as given in Figure 6.7 Electrical wiring dia-
4.
gram
→
47 and fit a 10 A thermal cut out upstream of the Comfort Control Panel.
How to connect the plant water circulation pump
Before making the electrical connections, make sure that work is not carried out on live
elements.
To optimise the operation of the appliance it is necessary to install, on the primary circuit,
variable rate WILO STRATOS PARA pumps (see Section 8 ACCESSORIES
→
77) which are
controlled and modulated with the Robur Mod10 controller.
No other models pump are supported.
The instructions for connecting the WILO STRATOS PARA pumps are given below (see
Section 8 ACCESSORIES
→
77).
Each WILO pump includes its power cord and signal cable 0-10V (both 1.5 m long) for con-
nection to the appliance’s electrical panel. For longer cable runs, use a shielded 2x0.75
mm
2
0-10V signal cable and a FG7 3Gx2.5mm
2
power cord.
You will need: the appliance in its permanent location.
Check that power supply is off.
1.
Remove the front panel of the appliance and the cover of the electrical panel.
2.
Connect the brown wire of the WILO STRATOS PARA pump on the terminal "-" of
3.
the connector HPMP on the Mod10 board. Connect the white wire of the WILO
STRATOS PARA pump on the terminal "+" of the connector HPMP on the Mod10
board. Insulated black and blue wires (see Figure 6.15 Wiring diagram for connec-
tion of Wilo variable rate pumps
→
55).
Connect the pump to the mains with an upstream external bipolar switch (see de-
4.
tail IP, Figure 6.15 Wiring diagram for connection of Wilo variable rate pumps
→
55)
with a delayed action 2 A fuse, or connect it to the terminal clamps inside the units
electrical enclosure (see detail MA, Figure 6.16 Wiring diagram for hooking up the
Wilo variable rate pump powered by the unit
→
56).
After finished with all the above operations, close the electrical panel and refit the
5.
front panel of the appliance.
NEVER switch on or off the WILO STRATOS PARA pump through the switch on the power
supply.
