40
6
eLeCtRICAL InstALLAtIon
This section illustrates the operations to perform for the correct electrical installation of
the appliance, and contains electrical diagrams that may be of use in the event of main-
tenance operations.
Installation of the appliance may only be carried out by firms that are qualified in accord-
ance with current legislation in the country of installation, i.e. by professionally qualified
personnel.
Before proceeding with operations to create the electrical plant of the appliance, the
professionally qualified personnel concerned are advised to read Paragraph 3.1 GENERAL
INFORMATION
→
8: it provides important information regarding installation safety and
references to current norms.
Installation that is incorrect or that does not comply with current legislation may cause
damage to people, animals or things; Robur S.p.A. is not responsible for any damage
caused by installation that is incorrect or that does not comply with current legislation.
Figure 6.1 Electronic board S61
→
41 and Table 6.1 Electronic board S61
→
41 provide de-
tails of input and ouput of the S61 electronic board. The auxiliary electronic card Mod10
is shown in detail in Figure.
6.2 Mod10 controller
→
42.
The appliance and the system can be controlled and regulated in one of the following
ways depending on the type of installation and control system selected:
•
tYPe A: controlled by CCP (see Figure 6.3 Comfort Control Panel e Accessory
→
43,
detail CCP).
•
tYPe B: controlled by DDC (see Figure 6.4 CCI/DDC
→
44).
•
tYPe C: controlled by consent switch (e.g. on-off switch, ambient thermostat, tim-
er, etc.).
In Paragraph 6.1 ELECTRICAL DIAGRAM OF THE APPLIANCE
→
45 may be found the Elec-
trical diagrams of the appliance.
