Robox 3d printer, User Manual

Page: 17 / 122

17 17
www.cel-robox.com
1.0 Introduction
1.12 Regulatory and Environmental Information
1.12.1 Electromagnetic Interference
The normal functionality of the product may be disturbed by Strong Electro Magnetic Interference.
If you are experiencing problems, reset the product by cycling the power to resume normal
operation. If normal functionality does not resume, please try using the product in a different
location.
1.12.2 FCC Statements (U.S.A.)
The U.S. Federal Communications Commission (in 47 cfr1 5.105) has specified that the following
notices be brought to the attention of users of this product.
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Shielded cables: use of shielded data cables is required to comply with the Class A limits of Part 15
of the FCC Rules.
Caution: Pursuant to Part 15.21 of the FCC Rules, any changes or modifications to this equipment
not expressly approved by CEL Technology Ltd. may cause harmful interference and void the FCC
authorization to operate this equipment.
Note: This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a commercial environment. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference, in which case the user will be
required to correct the interference at their own expense.
1.12.3 Canada Electromagnetic Compatibility (EMC)
•
Normes de sécurité (Canada)
Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites
applicables aux appareils numériques de Classe A prescrites dans le réglement sur le
brouillage radioélectrique édicté par le Ministère des Communications du Canada.
•
DOC statement (Canada)
This digital apparatus does not exceed the Class A limits for radio noise emissions from digital
apparatus set out in the Radio Interference Regulations of the Canadian Department of
Communications.
1.12.4 MSDS (Material Safety Data Sheets)
You can obtain current Material Safety Data Sheets for the materials used in the product at: www.
cel-robox.com/materials