Robox 3d printer, User Manual, Page: 41 / 122

41 41
www.cel-robox.com
4.0 Using Robox
4.5 Removing the Bed
To remove the PEI bed from your Robox®, simply slide the handle on the front of
the bed (highlighted in blue) to the left to release. Then lift up the front edge of
the board using the finger recess (shown by the hand) and slide the bed towards
you.
4.6 Installing the Bed
To re-install the bed, simply slide the sheet towards the back of the tray, ensuring
the tabs are aligned beneath the 4 metal clips on the sides, and then push all the
way to the back until it slides under the rear clip and stops. Then simply slide the
handle on the front to the right, securing it in position.