ROBOTIQ FT 150, Instruction Manual

Page: 42 / 62

Robotiq FT-150/300 Sensor Instruction Manual
Robotiq inc. © 2016 42
1.
2.
3.
4.
5.
6.
7.
4.5 Visual Demo Software
The Visual Demo Software is used to demonstrate the
ability of the FT Sensor to read force and momentum. It is
not intended to be used for programming or to save or use
data.
It can also be used to calibrate the Sensor; see
Section 3.6.2
for the calibration
procedure.
Software Package Installation
Make sure that you have the latest version of the Visual Demo Software, which can be found at support.roboti
. q.com
Copy all the files of this folder onto a PC.
Connect the USB connector to the converter attached to the PC. Important : The Sensor must NOT be
powered at this time.
Wait while the driver(s) install. After all the drivers have been installed.
Plug the Sensor cable into the Sensor.
Connect the Sensor cable to the power supply.
Launch the demo application.