Roborock S6 Pure, User Manual

Page: 19 / 37

15
Instructions for Use
Start cleanup
Note:
• Cleaning cannot start if the battery level is too low. Allow the robot to charge
before restarting cleanup.
• Tidy away any cables on the ground (including the power cable of the charging
dock) before cleaning to avoid losing power or damaging either the robot or the
connected device.
• If a cleanup finishes within 10 minutes, cleaning repeats by default.
• If the battery runs low before cleanup is complete, the robot will carry out a top-up
charge before resuming cleanup from where it left off.
Pause
When the robot is cleaning, press any button to pause it.
Then press the button to continue cleaning or the
button to return it to the charging dock and stop the
cleaning cycle.
Note:
Placing a paused robot on the charging dock manually will end the current cleanup.
Sleep
If the robot is paused for over 10-minutes, it will go to sleep,
and its power indicator will flash slowly. Press any button to
wake it back up.
Note:
• The robot will not go to sleep when it is on the charging dock.
• The robot will automatically shut down if left in sleep mode for more than 12
hours.
Start cleanup
Auto: After cleaning, the robot will automatically return to
the charging dock to recharge.
Manual: In Pause mode, press the button to send the
robot back to the charging dock.
The power indicator will flash slowly as the robot charges.
Note:
If the cleaning cycle was started away from the charging dock and the robot could not
return to the dock after cleaning, it will instead return to its starting point. Place the
robot directly on the dock to recharge it.
Error
If an error occurs while the robot is cleaning, the power
indicator will flash red quickly, and you will hear a voice
alert. See "Troubleshooting" for resolution options.
Note:
• The robot will go to sleep automatically if left in an Error state for over 10-minutes.
• Placing the robot on the charging dock in an error state will stop the current
cleanup.
Reset WiFi
If your phone cannot connect to the robot because you have
changed your router configuration, forgotten your password,
or any other reason, open the top cover to see the WiFi
indicator light, then press and hold the Spot Cleaning button
and the Recharge button until you hear the "Resetting WiFi"
voice alert. When the WiFi indicator light flashes slowly, the
robot has entered network configuration mode.
Note:
If the robot is left connecting to the network for over an hour, its WiFi will be disabled.
Reset WiFi before attempting reconnection.